Maintenance

• After using the product, be sure to turn it off and make sure the remote control and battery are turned off.
• Please check the status of each module regularly and check that there is no damage to waterproof parts, such as remote controls, batteries, mast heads, etc.
• Clean power system, use clean fresh water one by one, the mast, the upper seat of the mast, the mast DC port, the motor, the propeller and the protective cover, to ensure that there are no seawater, sand or other debris residues. Use an alcohol swab to clean the DC port to ensure it is dry and free of impurities.
• Clean the board body, rinse the board body, battery compartment, mast mounting position and other parts with clean fresh water to ensure that no seawater, sand or other debris remains. Then let it sit in a dry environment or use a dry towel to remove the remaining moisture.
• To clean the battery, rinse the outside of the battery with clean fresh water, clean the battery DC port with a cotton swab dipped in a small amount of alcohol, then wipe the battery with a dry towel, and finally leave it in a dry environment to remove the remaining moisture.
• When cleaning the remote control, rinse the outside of the remote control and the trigger position with clean water. If the trigger jams, please check whether there are gravels in the trigger. If there are any, remove them and rinse them again with clean water.
• After cleaning is completed, wait for all parts to dry before placing the parts back into the packaging.
• Please ensure that the area where this product is stored is not exposed to direct sunlight, as ultraviolet rays and high temperatures can cause permanent damage to the product.